Feature | Night Reader Pro – Instructions

Night Reader Pro – Instructions

The Night Reader Pro™ uses advanced programming to provide several features with easy to use one button control.  The Night Reader Pro™ gives you the following useful modes of operation:

Click Here for Battery Replacement Instructions

Instant Full Power On/Off

Simply press and release the button for instant on at full power. One press and release will turn the light off again.

Adjustable Brightness

To gradually ramp up from Off:
Simply press and hold until desired brightness is reached.
The light will blink once when you have reached the highest setting.

To gradually ramp down from Full Brightness:
Simply press and hold until desired brightness is reached.
The light will blink once when you have reached the lowest setting.

Note: You can continue to ramp up or down from any brightness setting not just from On or Off.

– To exit this mode, simply turn the light off.

Three-Minute Timer Mode

The three Minute Timer mode automatically shuts the light Off after three minutes. While in this mode you have full access to the full range brightness control, the three strobe beacons and automatic SOS all of which will shut off after three minutes. This mode is great because it allows you to use the lights full functionality and is a guarantee against inadvertent battery drain.

To access this mode press the button rapidly four times or until the light only stays on when pressed. Next press and hold the button, the light will turn itself Off, continue to hold the button for another five seconds, the light will blink once to let you know you are now in Three Minute Timer mode.

To exit this mode press the button rapidly four times or until the light stays on only when pressed. Next hold the button for four seconds or until the light shuts off. And you have exited the Three Minute Timer mode!

Strobe Beacons

Beacon mode gives you Slow Medium or Fast Strobe and an automatic SOS signal mode. Great for use as emergency warning lights, trail markers, or to attract attention in any situation.

To Access from either Off or On
Simply press and hold. The light will ramp up or down in brightness then blink once. Continue holding the button down after the single blink. You have reached Slow strobe, continue holding to reach Medium and Fast strobe, continue holding to reach the SOS signal mode.  Release the button when the desired beacon mode is reached.  In SOS signal mode the light will flash the letters S-O-S in Morse Code.

To exit any of these modes, simply turn the light off.

Signal/Momentary Mode

Momentary mode changes your light from constant On to squeeze On/Off. When this mode is activated the light will not stay on unless the button is pushed and held. This is very useful when carrying your light on your keys or in a bag. It also allows you to use the light as a signaling device.

To access this mode press the button rapidly 4 times, or until it the light stays on only when pressed.

To exit this mode, simply press and hold the button until the light turns off (about 4 seconds).